Method of pump, pipe, and tank selection for aeroponic nutrient management systems based on crop requirements

  • Milon Chowdhury Department of Agricultural Machinery Engineering, Chungnam National University, Daejeon, Republic of Korea; Department of Smart Agriculture Systems, Chungnam National University, Daejeon, Korea, Republic of. https://orcid.org/0000-0002-9887-7980
  • Md. Shaha Nur Kabir Department of Agricultural and Industrial Engineering, Hajee Mohammad Danesh Science and Technology University, Dinajpur, Bangladesh.
  • Hyeon-Tae Kim Department of Biosystems Machinery Engineering, Gyeongsang National University, Jinju, Korea, Republic of.
  • Sun-Ok Chung | sochung@cnu.ac.kr Department of Agricultural Machinery Engineering, Chungnam National University, Daejeon, Republic of Korea; Department of Smart Agriculture Systems, Chungnam National University, Daejeon, Korea, Republic of.

Abstract

The system-specific selection of aeroponic nutrient system components, specifically pumps, pipes, and tanks, is very important to improve system efficiency and minimize costs, as these components vary for different systems with different crop water requirements and design specifications. In this study, methods were suggested for determining the most suitable sizes of pumps, pipes, and tanks based on the plant water consumption and irrigation interval targeted to improve the usual procedures to design an aeroponic nutrient management system, and applied to a case. Factors affecting the size calculation are discussed, and calculation methods were suggested based on basic hydraulic principles. A recycle-type aeroponic nutrient management system, cultivating 500 plants in 21 plant beds, was considered for a case study. Application of the size calculation methods in the case study showed that an irrigation pump with a 37 Lmin–1 flow rate at 900 kPa capacity and nutrient pumps with a 5 Lmin–1 flow rate at 40 kPa capacity with 19-mmdiameter pipes were required to deliver the mixed nutrients and supply stock solutions into the mixing tank, along with nutrient mixing, stock nutrients, and distilled water tanks of 750, 40, and 685 L, respectively. Calculation was demonstrated to show the variations in the sizing of the pumps, pipes, and tanks by number of plants. Validation tests were performed for the selected irrigation pump capacity, and the results showed that the Nash-Sutcliffe efficiency coefficient (NSE), coefficient of determination (R2), and root-mean-square error (RMSE) values were 0.410, 0.98, 0.109 Lmin–1 and 0.775, 0.99, 34.91 kPa for flow rate and pressure, respectively. The case study also showed that these sizing procedures increased the plant bed coverage efficiency of the irrigation pump by 33%, while increasing the nutrient mixing tank size by 133%. This study would provide useful information on the efficient sizing of pumps, pipes, and tanks for minimizing costs and maximizing crop production in aeroponic nutrient management systems.

Dimensions

Altmetric

PlumX Metrics

Downloads

Download data is not yet available.
Published
2020-06-18
Info
Issue
Section
Original Articles
Keywords:
Aeroponic crop cultivation, nutrient management, irrigation, size selection.
Statistics
  • Abstract views: 58

  • PDF: 47
  • HTML: 0
How to Cite
Chowdhury, M., Kabir, M. S. N., Kim, H.-T., & Chung, S.-O. (2020). Method of pump, pipe, and tank selection for aeroponic nutrient management systems based on crop requirements. Journal of Agricultural Engineering, 51(2), 119-128. https://doi.org/10.4081/jae.2020.1028